Connecting your LaserKube is very simple.
Connect the power cord to a 2P+T 230V 16A socket and the USB cable to your PC.
The 2 sockets are located at the rear of the machine (Figure 1).
Power cord
Use only the power cord supplied with your LaserKube.
Please note that the mains plug is fitted with a locking system to prevent accidental disconnection.
To disconnect the mains plug from the machine, unlock the plug by pulling the red knob in the direction of the arrow (figure 2).
USB cable
Use only the cord supplied with the machine.
Connect the USB cable to the machine and to your PC.
At the same time, the USB link enables :
- Control the laser,
- Recover the video stream from the machine’s internal camera.
The driver and EZCad software are installed in the software installation section.